Porter Cable PC1800L Manual De Instrucciones página 3

90546221 pc1800l pcl180l
The correct power tool will do the job better and safer at the rate for which it was
designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the
power tool before making any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce the risk of starting the power
tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tool's
operation. If damaged, have the power tool repaired before use. Many
accidents are caused by poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
5) Battery tool use and care
a) Recharge only with the charger specified by the manufacturer. A charger that
is suitable for one type of battery pack may create a risk of fire when used with
another battery pack.
b) Use power tools only with specifically designated battery packs. Use of any
other battery packs may create a risk of injury and fire.
c) When battery pack is not in use, keep it away from other metal objects like
paper clips, coins, keys, nails, screws, or other small metal objects that can
make a connection from one terminal to another. Shorting the battery terminals
together may cause burns or a fire.
d) Under abusive conditions, liquid may be ejected from the battery, avoid
contact. If contact accidentally occurs, flush with water. If liquid contacts
eyes, additionally seek medical help. Liquid ejected from the battery may cause
irritation or burns.
6) Service
a) Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
IMPORTANT SAFETY
INSTRUCTIONS FOR FLASHLIGHTS
WARNING:
PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE
FOLLOWING:
• READ ALL THE INSTRUCTIONS BEFORE USING THE APPLIANCE.
• To reduce the risk of injury, close supervision is necessary when an appliance is used
near children.
• Only use attachments recommended or sold by the manufacturer.
• To reduce the risk of electrical shock, do not put light in water or other liquid. Do not
place or store appliance where it can fall or be pulled into a tub or sink.
• Use only the charger supplied by the manufacturer to recharge.
• During or immediately after use, don't lay light flat on lens surface.
• Replace broken bulb in a well ventilated area.
• Don't touch lens surface when bulb is lit or immediately after use.
• Handle light with care around any flammable surface.
• Do not expose light or charger to wet or damp areas. Do not expose light or charger
to rain or snow.
1/5/09 12:34 PM Page 3
WHEN USING ELECTRIC APPLIANCES, BASIC
3