Publicidad
SE1
SE2
SE3
SE4
SE5
18
English
6. Set up
■ MOUNTING OTHER PARTS
1. Insert the driveshaft into the clutch drum, then attach
the gearbox to the shaft tube as aligning the
positioning holes. Wipe out grease on the tube and
the inside of the gearbox. Screw in the lock screw
and fasten the clamp bolt firmly. (SE1)
(1) Clamp bolt
(2) Lock screw
2. Install the blade guard to the gear case with the
provided 3 screws, then clamp it to the shaft tube
with 2 screws. (SE2)
3. Place the blade between the cutter holders (A) and
(B) while locking the gear shaft by putting the bar,
one of the tools provided, through the key holes on
the holder(A) and the gearcase. Use the socket and
the screwdriver as shown in the picture below to
tighten the blade mounting bolt. (SE3)
(1) Blade mounting bolt (Left-handed)
(2) Cutter holder (B)
(3) Blade
(4) Bar
(5) Cutter holder (A)
4. Split the bracket and install the wheel assembly to
the shaft tube and clamp at a position best for your
job. (SE4)
(1)Bracket
5. Install the handle to the shaft tube and clamp at a
position best for your job. (SE5)
Publicidad
