●Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a
non-wax furniture polish. Do not use car wax. Do not use abrasive cleaners.
●Do not drive the vehicle in loose dirt, sand or fine gravel which could damage
moving parts, motors or the electric system.
●When not using, all the electrical source should be turn off. Turn off the power
switch and disconnect the battery connection.
Charge the Battery
The first charge will take about 12 hours.
1. Open the battery charger port (located on the dashboard).
2. Insert the battery charger connector into the charger port.
3. Plug the charger into a standard 120V/220V wall outlet. Note: The charger may feel warm during charging.
This is normal and not a cause for concern.
4. After charging is complete (at least 8-10 hours, but not more than 24 hours, with the first charge taking
about 12 hours) unplug the charger from the wall outlet and unplug the battery connector from the charger port.
• Plug the battery connector into the charger port.
• Plug the charger into a standard wal I outlet.
• Only u s e t h e 12 v olt charger to charge y our 12 v olt b attery.
• Note: if power flow to the wall outlet is controlled by a switch , make sure the switch is "ON".
• Before first-time use, charge the battery for at least 12 hours. Never charge the battery longer than 24 hours.
• Recharge the battery for at least 8-10 hours after each use of your vehicle.
• Do not charge the battery longer than 24 hours.
• Do not charge or store battery upside down. Charging produces explosive gases. Charge away from flames,
sparks and lit cigarettes. Charge in a well ventilated area.
• Once the battery is charged, disconnect the battery connector from the charger connector. Unplug the
charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the following
Battery Installation Section for detailed instructions on installing your vehicle:
Battery Replacement
1. Remove the screw on the back of the seats and
lift the seat out.
2. Disconnect the battery connectors.
3. Remove the four screws on the sides of the battery.
4. Carefully lift the battery out of the battery compartment.
5