Remington S1001 Manual Del Usuario página 4

ENGLISH
Before use, make sure hair is clean, dry and tangle-free.
Plug in the unit, the on-indicator will glow red and the styler will be ready to use, in
approximately 30 seconds.
For extra protection and best results, section hair prior to straightening and spray with
heat protection spray. Always straighten the lower layers first.
Run the straightener through the entire length of the hair, without stopping.
Repeat only twice per section to prevent hair damage.
When used at 120V the heat up times & temperatures may vary.
Due to the extreme heat capabilities of this styler, extra care should be taken when
using.
While heating, during use and cooling, place on flat, smooth, heat-resistant surface. Only
hold unit at the end of the handle.
This is a high performance product, avoid frequent use to prevent damage to hair.
Please note regular use of styling products may deteriorate the coating.
Do not scratch the surface, as this will deteriorate the effectiveness of the coating.
Ensure the unit is unplugged and cool. Wipe clean any build up of styling products with a
damp cloth. Do not use an abrasive cleaning fluid to clean, as damage will occur.
WARNING – FOR ADDITIONAL PROTECTION THE INSTALLATION
OF A RESIDUAL CURRENT DEVICE (RCD) WITH A RATED RESIDUAL
OPERATING CURRENT NOT EXCEEDING 30mA IS ADVISABLE. ASK AN
ELECTRICIAN FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN INTO A BATHROOM.
IT SHOULD NOT BE USED NEAR BATHTUBS, SHOWERS, BASINS OR
OTHER VESSELS CONTAINING WATER OR OTHER LIQUIDS.
2
100193_REM_IFU_S1001 21L.indd GB_2 100193_REM_IFU_S1001 21L.indd GB_2
INSTRUCTIONS FOR USE
IMPORTANT INSTRUCTIONS
CLEANING AND MAINTENANCE
SAFETY CAUTIONS
30.03.10 18:33 30.03.10 18:33