Publicidad
Idiomas disponibles
Idiomas disponibles
2. Place the tank seat on the ground and place a 20 lb LP gas tank into the designated area
in the center. Once the tank is level and steady, tighten down the screw on the side of the
tank seat to secure the tank in place.
3. Connect the LP Gas Tank
Before connection, be sure there is no debris caught in the
collar of the LP gas tank, the regulator valve, the burner
tube, or the burner ports.
Connect the gas line to the tank by turning the connection
knob clockwise. Hand-tighten only.
Disconnect the LP Gas Tank
To disconnect the LP gas tank, make sure the valve on the
LP gas tank is completely closed.
Disconnect the connection knob by turning it counterclockwise
until it is detached from the valve.
4. If you wish to enclose your LP tank in a decorative tank cover, we recommend using the
Jensen Company model 133 Tank Cover. Any enclosure used must have a 0.5" (1.27 cm)
air gap around the entire base AND at least two 7" x 1.5" openings located on two di erent
sides of the enclosure. These openings must be within 5" of the top of the enclosure. If
the propane tank leaks, these ventilation openings will allow the enclosure to vent. Not
having the proper ventilation could result in property damage, personal injury or death.
WARNING
!
If the table is installed with a portion of the hose
under the table, the hose must be secured, so
that no part of the hose will be within 1" or
come in contact with the underside of the burn
pan or where the hose will not be accidentally
damaged or pinched.
Failure to secure the hose in a safe location may
result in a gas leak that could cause property
damage, injury, or death. Follow all other hose
inspection instructions listed in this manual.
!
WARNING
Place the LP gas tank 56 inches (142.2 cm) away from the
fireplace and position the hose away from pathways or
places where it could become damaged.
Watch your step while moving between the tank and the
fireplace. Be careful not to trip on the hose.
ASSEMBLY INSTRUCTIONS
56"
Coil near a corner that is
adjacent from the valve.
9
Valve
The hose should not come within 1"
1"
from the bottom of the burn pan.
Do not coil the hose
beneath the valve.
56"
Publicidad
