Publicidad
Idiomas disponibles
Idiomas disponibles
2.3 Placement
2.4 Start to use
2.5 Recommended layout for beverage can in the cabinet
Do not let the beverage can tough the back side of cooler in order to maintain good air circulation in the cabinet.
The capacity of beverage can storage (CE-LC49G-SQ shown as Fig.1 CE-LC99G-SQ shown as Fig.2)
is calculated based on the standard size can 355ml(outline size Φ65mm*125mm,12oz) , oversized beverage
can may impact on the number of can storage in the cabinet.
Inner row
Top shelf-12 cans
Base-9 cans
Avoid direct sunlight and heat
sources such as stove, heating
radiator, etc. If the cooler has
to be put next to heat source,
a suitable insulation board shall
be applied or keep the cooler
away from heat source.
After transportation, please let the cooler stay for more than 2 hours before turning on the
power, otherwise it will lead to a decrease in cooling capacity or a damage to the cooler .
The cooler shall stay for half an hour before connecting power when it is firstly started.
Clean up the inner chamber before put into use for first time .
Please pull out plug in case of power failure or cleaning. Do not connect the cooler to power
supply within five minutes to prevent damages to the compressor due to successive starts.
In the process of compressor work, water droplets or frost will be formed on the back wall
of the refrigerated compartment, which is a normal phenomenon. After a period of time, the
frost will melt into water and flow into the water tray to evaporate away.
Do not connect cooler to electronic energy saving plug and converter that can convert DC
into AC (E.g.: solar energy system, ship grid).
Outer row
Top shelf-11 cans
Base-16 cans
Fig:1
The top space of the cooler
shall be greater than 30cm,and
the distances from bothsides
and backside shall be more
than 10cm to facilitate heat
dissipation.
,
Total beverage
can storage-48cans
8
Publicidad
