Publicidad
Idiomas disponibles
Idiomas disponibles
EN
7
PROPOSITION 65
This product contains a chemical known to the
state of California to cause cancer, birth defects
or other reproductive harm. Some dust created by
power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to
cause cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•
Lead from lead-based paints;
•
Crystalline silica from bricks and cement and other
masonry products;
•
Arsenic and chromium from chemically treated
lumber.
Your risk of exposure to these chemicals varies
depending on how often you do this type of work. To
reduce your exposure to these chemicals, work in a
well-ventilated area, and work with approved safety
equipment, such as dust masks that are specially
designed to filter out microscopic particles.
Save these instructions.
8
INSTALLATION
Do not change or use accessories that are not
recommended by the manufacturer.
Do not install battery pack until you assemble all the
parts.
8.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If parts of the machine are damaged, do not use
the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If parts are damaged or missing, contact the
service center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
WARNING
WARNING
WARNING
WARNING
WARNING
English
5. Discard the box and packing material in compliance
with local regulations.
For your personal safety, do not insert battery before
the tool is assembled completely.
8.2
ADD THE BAR AND CHAIN OIL
Examine the amount of oil in the machine. If the oil level
is low, add the bar and chain oil as follows.
Use bar and chain oil that is only for chains and chain
oilers.
The machine comes from the factory without bar and
chain oil.
1. Loosen and remove the cap (8) from the oil tank.
2. Put the oil into the oil tank.
3. Monitor the oil indicator (7) to make sure that no dirt
gets into the oil tank while you add the oil.
4. Put the oil cap on.
5. Tighten the oil cap.
6. The whole oil tank will last for approximately 20- 40
minutes.
Do not use dirty, used or contaminated oil. Damage
can occur to the bar or chain.
8.3
INSTALL THE BATTERY PACK
18
15
8
WARNING
IMPORTANT
NOTE
8
IMPORTANT
7
Publicidad
