Publicidad
Idiomas disponibles
Idiomas disponibles
Troubleshooting Guide
PROBLEM
Duster/Dryer does
not start
Unit runs but the
speed / noise is
abnormal
Unit runs but the
machine gets very
hot
If troubleshooting does not resolve your problem, please contact XPOWER or other
parties authorized by XPOWER for further instructions.
English - 14
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
The circuit breaker of the
power socket or power circuit
jumps.
The thermal switch is triggered.
Air inlet or air outlet is blocked.
Carbon brushes of the motor
are worn out.
Leakage on the hose.
The motor produces heat and
heats up the machine after a
long time use.
SOLUTION
Check for power supply.
Remove and reconnect the
power cord.
Disconnect the machine to
the power socket. Reset the
circuit breaker and reconnect.
Turn off and unplug the
machine. Clean or replace
the filters. Plug and use again
after the machine totally cools
down.
Remove blockage, clean or
replace the filters.
Contact XPOWER for more
assistance.
Try to fix the leakage or
replace the hose.
(See Page
13: Hose Maintenance)
Turn off the machine. Use
again after the machine
totally cools down.
Publicidad
