Garland SCAR 501 E Instrucciones De Montaje página 26

English
6. START UP INSTRUCTIONS
6.1. LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Scarifier.
• Catcher.
• Top handle.
• Intermediate handle.
• Lower handle.
• Lower handle screws.
• Handle screw and knob.
• Hook for cable.
• Scarifying cylinder (mounted on the machine).
• Instruction manual.
Remove carefully all the elements from the box and
make sure that all listed parts are included.
Due to the quality controls done at the factory it is
highly improbable that your machine has any faulty
part or that any elements are missing. If you find any
damaged part or there are any elements missing,
do not use the machine until the problem has been
solved or you have been given the missing parts.
Usage of the machine with defective or missing parts
is dangerous and could result in personal injuries.
6.2. MOUNTING THE HANDLE
The handle comes unmounted from the manufacturing
plant. To mount the handle:
1. Place the scarifier on a flat surface.
2. Insert the lower
handles on the
scarifier as shown
in the figure and
hold in place with
the screws.
3. Place the intermediate handle
on the lower handle and
hold in place with the screws
and knob provided.
4. Place the top handle and hold the screws and
knobs provided.
6.3 INSTALLATION OF THE CATCHER
Place the catcher on the scarifier by hooking the
catcher on the hooks on the rear part of the machine.
To do this, hold the catcher by the top handle provided
with your right hand, lift the security trap with your left
hand up to its maximum point and hook the catcher
on the machine.
1
3
6.4. HOLDING THE CABLE EXTENSION
Only use cable extensions that are certified for
outdoor use. The cable section must be at least
26/100
2