Tripp-Lite SmartPro SMART2200RM2U Manual Del Usuario página 8

Optional Installation
External Battery Connection
3
(Select Models)
Your UPS comes with a robust internal
battery system; external batteries are
needed only to extend runtime. Adding
external batteries will increase recharge
time as well as runtime. This UPS supports
BP48V24-2U (limit 1) and BP48V60RT-3U
(unlimited).
The illustration (see
you will insert the battery pack cable. Complete installation instructions for your battery pack
appear in the battery pack owner's manual. Make sure that cables are fully inserted into their
connectors. Small sparks may result during battery connection; this is normal.
Do not connect or disconnect battery packs when the UPS is running on battery power.
Caution! When an external battery pack is connected, make sure the AC load does not
exceed the nameplate rating. Select models are derated when an external battery pack
is connected. See UPS nameplate label for derating details.
When connecting external batteries to the UPS, go to the Tripp Lite website at www.tripplite.
com/en/support/bpconfig/index.cfm to download the External Battery Pack Utility software to
configure your UPS for external battery support.
Note:
1. The runtime and charger rate will automatically recalculate once the External Battery Pack Tool process is
complete.
2. If the setup will no longer include external batteries, the UPS can be configured to work without external
batteries via the LCD Screen. See External Battery Settings Control section under Basic Operation for
details.
3. If external battery packs are removed, the UPS must be reset to "NO EXTERNAL BATTERY" via the LCD
interface or the External Battery Configuration Program available on the Tripp Lite website. Failure to do
so may result in damage to the internal batteries due to over-charging.
15-06-021-93-3088.indb 8
continued
) shows the location of your UPS's External Battery Connector
3
3
8
A
where
A
6/3/2015 10:09:22 AM