Publicidad
Idiomas disponibles
Idiomas disponibles
EN
DISASSEMBLY INSTRUCTIONS.
Unlock the sanp joint of protection plate if it is
blocked (A). Press the sanap joint for protection
plate and then take out the plate (A).
Take off the sanp joint and pull out on the outer
ptotection lens ( C ). Remove ptotective film
from lens. Place inside protection lens ( C ) back
into the front of the helmet by inserting one
side of the lens into either side slot and then
bend the lens just enough that it will slip into
the other side slot.
Take out the filter assembly from the Shell and
change the filter assembly ( G ).
Change another protection plate and insert the
sanp joint and then lock it (B).
Use a tool to pull out the 3 round knob covers
on the adjustment panel. Use a screwdriver to
pick out the 2 small switch covers from one side
(D). Take out the cover of the adjustament panel
from the shell ( E ). Loosen all five screws on the
filter ( F ).
Place the adjustment panel cover back, and
tighten all the five screws. Rotate the 3 axes of
round knobs counter-clockwise to the maximun
position, place each knob cover back on related
axis with arrow pointed to the maximun
direction. Move the switch knob to one side,
place back the switch cover accurately. Please
be careful. Otherwise iit´s easily to break the
switch knob inside ( HIJ ).
27
Publicidad
