Publicidad
Step 22
Carefully stand your unit upright.
å
Before fastening the DOOR to your unit, be sure the
å
mounting screw is against the stops as shown in the right
diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the DOOR (S) to the RIGHT UPRIGHT (E) as
å
shown in the lower diagram. Use the screws in the
HINGES. You should start each SCREW a few turns before
completely tightening any of them.
Fasten the KNOB SET (CCC) to the DOOR (S). Use a
å
SILVER 1-1/4" MACHINE SCREW (MMM).
Peel the FELT DISC from the FELT DISC CARD (JJJ).
å
Stick the FELT DISCS on the DOOR where they come in
contact with the LEFT UPRIGHT (F).
See the next step for DOOR adjustments.
å
www.sauder.com/services
E
F
MMM
SILVER 1-1/4" MACHINE SCREW
(1 used in this step)
401634
Pro Tip: Lift with your
legs. And, you know,
your arms.
Stop
Mounting
screw
Hinge
JJJ
CCC
S
JJJ
Page 27
Publicidad
