Publicidad
Idiomas disponibles
Idiomas disponibles
With the thumbwheel for pre-tension of the base
plate 21, the pre-tension of the SDS lever for
base-plate adjustment 22 can be adjusted. If the
base plate 7 is not seated tightly after shutting the
SDS lever, release the SDS lever 22 and rotate
the thumbwheel for pre-tension of the base
plate 21 in the "+" direction.
If the base plate 7 can not be adjusted or only
with difficulty after releasing the SDS lever for
base-plate adjustment 22, rotate the thumbwheel
for pre-tension of the base plate 21 in the "–" di-
rection.
Offsetting the Base Plate
(see figure
)
D
For sawing close to edges, the base plate can be
offset to the rear:
Remove the dust cover 17.
Release the SDS lever for base-plate adjust-
ment 22 and slide the base plate toward the rear
to the stop.
If the base plate 7 can not be adjusted or only
with difficulty after releasing the SDS lever for
base-plate adjustment 22, rotate the thumbwheel
for pre-tension of the base plate 21 in the "–" di-
rection.
To lock the base plate 7, shut the SDS lever for
base-plate adjustment 22. Possibly the thumb-
wheel for pre-tension of the base plate 21 must
be turned toward the "+" direction.
– With the base plate offset, only the 0° (normal)
position can be used.
– The circle cutter/parallel guide 24 as well as
the splinter guard 23 cannot be used in this
case.
Sliding Shoe for Base Plate
(see figure
)
E
The aluminium base plate 7 is equipped with a
steel insert for maximum stability. It is intended
for sawing of metal surfaces or insensitive mate-
rials without using the sliding shoe 8.
When sawing materials that are easily scratched,
the sliding shoe 8 avoids scratching up sensitive
surfaces.
For mounting, insert the sliding shoe at the front
of the foot plate, lift at the rear and latch in.
Splinter Guard (see figure
To avoid fraying of the surface, press the splinter
guard with the notch facing upward 23 (as shown
in the figure) from below into the base plate 7.
When working with the sliding shoe 8, insert the
splinter guard 23 into the sliding shoe.
The splinter guard 23 can be inserted into the
base plate in 2 positions. For narrow saw blades,
insert the splinter guard fully to the front; for wider
saw blades, insert it further to the rear in the base
plate.
The splinter guard cannot be used for certain saw
blade types (e. g., saw blades with set teeth).
Dust/Chip Extraction
Vacuum Connection
The vacuum connection 6 is used to connect a
vacuum hose.
When inserting the vacuum connection 6 in the
base plate 7, make sure that the plastic tip of the
vacuum connection engages in the correspond-
ing hole of the motor casing (see figure
To enable optimum dust extraction, use the splin-
ter guard 23.
The machine can be connected directly to the
socket of a BTI all-purpose vacuum cleaner with
a remote starting device. The vacuum cleaner is
started automatically when the machine is
switched on.
The vacuum cleaner must be suitable for the ma-
terial to be worked.
When vacuuming dry dust that is especially detri-
mental to health or carcinogenic, use a special
vacuum cleaner.
For external dust extraction with a vacuum
cleaner, an extraction adapter must be used as
required (see accessories). Insert extraction
adapter and vacuum connection firmly.
English - 7
)
E
F
).
Publicidad
