Lenco L-101 Manual De Usuario página 6

1. Phono Stylus Cartridge
2. Turntable Platter
3. Lift Lever
4. Turntable Arm Lock
5. Auto Stop Control Switch
6. Speed Selection Switch
7. Turntable Shaft
8. Turntable Arm
9. RCA Output Jack
10. USB Jack
11. Power Adaptor Jack
12. Power ON/OFF Button
LISTENING TO A RECORD
1. Connect the RCA Output Jack to the external speaker system with the RCA cable (not included).
2. Raise the dust cover
3. Press the Power ON/OFF Button.
4. Place a record on the turntable platter and set the player speed to match the record speed.
NOTE: when playing a single (a 45 rpm record) and/or records with large centre holes, use the 45
rpm adapter.
Remove the needle cartridge protective cover and unlock the tone arm lock from the tone arm rest.
Push the lift lever backward, the tone arm will gently rise up. Gently move the tone arm to the
desired position over the record and the turntable platter will begin to rotate when the arm is
moved towards it if Auto Stop Control Switch is ON. Release the tone arm onto the turntable by
pushing the lift lever forward and the vinyl record will begin to play.
If the Auto Stop Control Switch is turned ON, the record will stop automatically when finished. If
Auto Stop Control Switch is turned OFF, the record will NOT stop automatically when finished; you
must push the lift lever backward to raise the tone arm and place it back in the rest and then turn off
the power to stop the turntable from spinning.
Remark: AUTO STOP function applies to most 33RPM vinyl records. However, for very few vinyl records,
it will stop when it does not come to the end, or it will not stop when it comes to the end when AUTO
STOP is ON.
6