Publicidad
Idiomas disponibles
Idiomas disponibles
CHARACTERISTICS
▶Power: 900/1.200/2.100W
ES
▶3 levels
▶Security grid
PT
PARTES DEL APARATO
EN
1
2
FR
3
1. Heater casing
2. Grid
3. On/off switch
4. Support
5. Mounting screw
6. Foundation
7. Support, lower section
8. Support, midsection
9. Support, upper section
10. Support, adjustable section
INSTALLATION
▶Place the bottom of the bracket (7, with the fixing plate) on the base
(6), so that the screw holes are aligned. Insert the 3 screws through
the double holes and tighten firmly. Place the protective cover over
the threaded connection (for this remove the cable holder for a
moment).
▶Attach the center part of the support (8) over the bottom part (7)
and fix it in place with one of the screws. Next, the upper part of the
bracket ((9), with the compression coupling) is fixed to the center
section, in the same way using a screw.
▶Insert the thinner, more adjustable part of the bracket (10) as far as
desired into the gray part of the compression fitting at the top of the
bracket. Slide the lock ring down over the thin section of the base
and screw securely onto the gray compression fitting.
▶Unscrew the mounting screw (5) almost completely out of the
mounting bracket. Place the head of the heater on top of the
adjustable bracket section so that the screw falls precisely into the
hole in the bracket. Now firmly tighten the screw (the screw must
Instruction manual
5
4
disappear into the thin section of the bracket and cannot protrude!).
The bracket section can rotate 360°, allowing the head of the patio
heater to point in any direction. The electrical cable can be secured
in the cable holders on the bracket.
▶Check that all connections are fully secure and that the patio heater
is in place before use.
▶The appliance must be placed at a minimum distance of 1 meter
from the nearest wall. The box with the switch must be at least 30
10
cm from the ceiling and 1.80 meters above the ground. The patio
heater must be placed firmly on a flat and horizontal surface.
9
FALL PROTECTION
8
▶The appliance is equipped with a fall protection. It will turn off
automatically if, despite the precautionary measures you have taken,
the device is dropped.
7
6
▶In this case, unplug the device immediately.
▶Always check the heater carefully for damage and then return it
to an upright position. Never use a damaged device but take it to
your dealer or a recognized service point for it to be checked and/
or repaired.
▶If you find no damage, place the patio heater in the 0 position, plug
in and operate through the pull cord. Monitor the patio heater closely
for the first fifteen minutes; If defects occur, unplug it immediately
and take it to your service point for repair
FUNCTIONING
▶Before connecting the device to the network, make sure that the
switch is in the "0" position.
▶Plug the power cord into the AC 220-240V~ 50Hz outlet.
▶Through the 3 power system you can start the appliance.
• POSITION 0: OFF position, no button pressed.
• POSITION 1: first speed - 900W
• POSITION 2: second speed - 1,200W
• POSITION 3: third speed - 2,100W
▶If you do not use the appliance for a long time, unplug the power
cord from the electrical outlet.
▶Never try to disassemble the device.
▶If you notice any abnormality (such as unusual noise from the
device), turn off the device and unplug it immediately.
▶Do not use this heater with a programmer, timer or other device that
switches the heater on automatically, as there is a risk of fire if the
heater is covered or incorrectly positioned
▶Make sure that no objects or liquids get inside the appliance through
the openings.
▶The device must only be used in dry environments. Do not use in the
Ref. 07093
Publicidad
