Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND USE OF THE SYSTEM
level, mark the locations of the screw holes. If
necessary, pre-drill the holes and use the wall
anchors provided. Fasten the mounting bracket to
the wall with the screws provided.
3. Place your unit against the wall and gently slide
the unit down into the locking position of the
mounting bracket slots.
4. Connect the cold water hose from your washer to
level, mark the locations of the screw holes. If
necessary, pre-drill the holes and use the wall
anchors provided. Fasten the mounting bracket to
the wall with the screws provided.
3
5. With the hose supplied, connect the "Cold Water"
fitting on the unit to your cold water supply faucet.
Make sure the rubber washers are in place and
tighten well, but DO NOT overtighten. Again, use a
wrench to hold the hose sleeve securely in the unit
while squeezing.
6. Plug the power adapter into the DC adapter plug
on the right side of your unit and then plug the
adapter into a power outlet.
7. Make sure that all hoses are properly installed
and tightened, and that the power supply is properly
installed. SLOWLY turn on the water supply and
check for leaks. Carefully tighten fittings if leaks are
evident, but DO NOT overtighten.
The hot water hose should not be disconnec-
ted from the washer. You can turn off the hot
water or leave it on, but the hose must be
installed in the washer to prevent water
back ow out of the washer during use.
9. PRODUCT USE
Indicator Light:
The Indicator Light, seen through the horizontal
window on the front of your unit has two operating
states.
• Blue light: indicates normal operation of the unit.
• Flashing red light: Indicates that the fan or
oxidation generator is not working properly. Contact
your dealer for service.
Household Cleaning
The same water that kills bacteria and germs on
your clothing can now be used for other household
cleaning purposes.
The "Direct Flow" accessory on the bottom of the unit
is used for general household needs such as
cleaning floors, avocados, watering plants, washing
pets, or even rinsing fruits and vegetables. By using
the "Direct Flow" accessory (included with your unit)
you can have ozonated water available for most
household cleaning purposes. Unfortunately, due to
the nature of oxidizers, you cannot obtain water from
the unit and store it for later use. The water used for
this type of cleaning should be used in 15-20
minutes.
WARNING: This water should not be
swallowed.
RESULT OF CONNECTIONS:
1
2
1. Connect the tap included in the supplied hose
and place it in the outlet shown in the drawing. With
this unit you can have ionized water available for
most household cleaning purposes.
2. Place the supplied hose in the cold water outlet
that will take you from your ozone equipment to the
washing machine.
3. Place the supplied hose from the cold water outlet
that previously went to your washing machine and
take it to the cold water inlet of your ozone
equipment.
21
3
EN
Publicidad
