Buffalo GH125 Manual Del Usuario página 6

UK
PROGRAM : There are a total of 6 programmable timer settings. The default factory program
settings are given below
Program
Factory
Preset 00:30
Time
To change the length of a program select the program you want to change by scrolling using the
PROGRAM button. Adjust the program time by using the UP and DOWN buttons. Press
START/STOP to commence the count-down. The new program time will be automatically stored.
If the unit is left without power for more than 24hrs the timer settings will revert to the
factory defaults.
Cleaning, Care and Maintenance
The Fryer should be cleaned after each day's operation; however it may require cleaning more
often, depending on the volume of frying carried out.
1. Switch off the power and disconnect from the power supply by removing the plug from the
socket.
2. The Fryer must be left until the oil has cooled to room temperature before cleaning.
3. Empty oil by opening the drain tap at the front of the unit
Note: If the oil is to be reused, it should be filtered
4. Once the oil has been emptied from the fryer, the control box can be tilted back enabling
the pan to be cleaned using warm soapy water.
Warm soapy water is recommended for cleaning. Cleaning agents after prolonged use can
cause damage to stainless steel.
The main body can also be cleaned with warm soapy water. Remove the control box and
element before cleaning takes place.
The control box cannot be immersed in water, but can be wiped down with a damp cloth.
After cleaning as above, please use a dry cloth to clean the appliance to ensure there is no
water on the heating element and in the water oil pan.
1 2
01:00
3 4
01:30 02:00
5 6
02:30 03:00