Bastilipo RC-Ecofluid-7 Manual De Instrucciones página 8

Warning
Dear customer,
We thank you very much for
having purchased one product
of ours. We kindly ask you to
read and save this instruction
manual.
Assembly of the heater
Remove the heater and all the
accessories from the carton. The base
must be fitted to the heater in
accordance with the details below.
NOTE: It is important that the base are
fitted to the correct (i.e. bottom) end of
the heater.
1. Turn the heater upside down.
2. Position the base between the end
fins.
3. Attach them to the heater using the
U-bolts and wing nuts supplied.
4. Tighten the wing nuts.
5. Turn the heater the right way up.
Parts description
1. Thermostat knob 2. Power switch 3.
Cord storage 4. Radiant fins
5. Castor
2
3
1. Thermostat control
2. Power selector
3. Cord storage
4. Radiator fins
5. Wheels
6. Humidifying container
Operating your Ecofluid
Place the heater on the floor at least
50 cm away from the wall and any
other objects such as furniture,
curtains or plants. (Make sure the
power supply used corresponds to
the one on the rating label) With the
thermostat control switch and the
power setting switches in the '0'
position, plug the heater into the main
power supply.
Room temperature can be adjusted
using the thermostat Simply. Turn the
thermostat knob clockwise, to
increase the heat, and anti-clockwise
to decrease the temperature, until
you reach the desired temperature.
Switch the heater to one of the
following power settings.
7
English
1
4
5