Briggs & Stratton NAX 700B Manual De Instrucciones página 35


Internal combustion tools must be maintained. Check alignment or jamming of moving parts, cracked parts and all
other factors that may affect the operation of the device. If damage is found, the equipment must be repaired
before use. Many accidents are caused by improper repair and / or maintenance of the equipment.

Before using the device, replace all defective, worn and damaged parts. Replace with new warning signs on the
device if they become illegible or damaged.

Warning decals and spare parts can be ordered from NAX service and authorized dealers.

An internal combustion tool, equipment, working tools etc. should be used in accordance with these instructions,
taking into account the conditions and the type of work to be performed. Using the device in a manner not intended
for it may be dangerous.
OPERATION AND EXPLOITATION OF TOOLS EQUIPPED WITH A BATTERY

Before inserting batteries into the tool, make sure that its on / off switch is in the "off" position. Inserting the
batteries into the device when the on / off switch is in the "on" position can cause serious injury.

Use only the charger recommended by the manufacturer. Using a charger to charge other types of batteries may
cause a fire.

Never use batteries other than those recommended by the manufacturer. Use of other batteries may result in
serious injury or fire.

When the device is not in use, remove the battery. The battery should be kept away from metal objects such as
paper clips, coins, nails, screws, etc., which may short-circuit the battery terminals. Shorting the battery terminals
together may cause burns or a fire.

Under extreme conditions, liquid may escape from the battery. You must avoid contact with it. If it accidentally it
comes into contact with liquid - rinse immediately with water. If liquid gets in your eyes, contact your doctor
immediately. Liquids leaking from the battery may cause irritation or burns.

It is forbidden to use chargers and power supplies outside the rooms and in rooms with high humidity such as
bathrooms or basements.
CAUTION! Chargers and power supplies for battery devices are intended for indoor use in a dry environment.
Danger of electric shock and / or damage to the device.
REPAIR

Before carrying out any adjustment, part replacement or storage, the spark plug wire must be removed. Such
preventive safety measures reduce the risk of accidental starting.

Repair should be performed by a qualified person using only original spare parts. This will ensure further safe
operation of the device. It is recommended to have any service performed by an authorized NAX service center.
CAUTION!
Danger of suffocation when children play with the packaging. The packaging, especially the foil bag,
should be stored out of the reach of children.
DETAILED SAFETY REGULATIONS FOR BRUSHCUTTERS

Observe all safety instructions, operation manual, descriptions and data supplied with the device. Failure to follow
the instructions below may pose a risk of serious injury.

Watch out for sharp knife edges and cutting line. The head of the brushcutter rotates even after starting the engine

You can only use the brushcutter in good technical condition, perform the necessary actions if necessary or contact
the service center. It is recommended to use the services of an authorized NAX service.

Before starting, check if:
 the device is assembled according to the operation manual,
 the cutting tool and the whole cutting unit (three-armed knife or head with a cutting line, fastening elements,
construction of the cutting unit) are in good technical condition; regularly check their attachment, damage and
wear (depressions, cracks),
 safety devices (e.g. cover, housing, handle, levers) are in good technical condition and work properly.

The brushcutter must not be turned on if the cutting tool is not mounted correctly. Danger of dangerous vibrations!

Cutting tools should be sharp and clean. Properly keeping sharp edges of cutting tools reduces the likelihood of
jamming and simplifies handling.

Before adjustment, cleaning, maintenance, switch off the device and remove the high voltage cable from the spark
plug.
EN 35