Descargar Imprimir esta página

IRIS Woozoo TWF-D81 Serie Manual Del Usuario página 3

Publicidad

Idiomas disponibles

Idiomas disponibles

If handled incorrectly, contents can lead to personal injury or physical damage.
Keep out of reach of children and infants .
Do not climb on or tip the product over . Doing so may lead to injury or electric shock .
Make sure to hold the handle while moving product . Do not drag the product when moving it . Dragging
product can damage carpet and floors .
Do not point air flow directly at your body . It generates a very strong air flow .
Be especially mindful not to allow children or elderly people near product . Being near the product can be
harmful to their physical condition and to their health .
Air blowing directly on plants may be harmful .
Do not strike the unit forcefully . Doing so can cause the product to malfunction, leading to fire or electric
shock .
User Servicing Instructions
If the fuse on your fan has blown, grasp the plug and remove it from the outlet . Do not pull the cord to unplug .
To open, slide the fuse cover towards the prongs of the plug .
Carefully remove the old fuse and snap the replacement fuse into place . To reduce the risk of fire, only
replace the fuse with another fuse of the proper rating (2 .5Amp, 120Volt) . Slide the fuse door back into place
to close . Discard the blown fuse . The plug should now be ready for normal use .
Risk of fire . Do not replace the attachment plug . Product contains a safety device (fuse) that should not be
removed . Discard the product if the attachment plug is damaged .
If you need further information on how or when to replace the fuse in plug, please contact IRIS USA, Inc .
customer service at 1-800-320-4747 .
3
ASSEMBLY
The tower fan comes disassembled . Please follow the instructions for proper assembly . The packaging materials
can be used for storing the product when not in use .
CAUTION
Do not plug the power plug in or operated the product before the product has been assembled .
1 Remove the screws from the main body.
Lay the main body flat and remove the screws attached to the
bottom of the product .
2 Install the base.
Pull the cord through the center hole of the base .
Fit the tabs of the back base through the holes of the front base
until the claws on the back base click firmly into place with the
front base .
3 Attach the base to the main body.
Align the screw holes of the assembled base with the screw holes
on the bottom of the main body . Fasten the base to the body with
the previously removed screws .
The front of the base should align with the front of the main body,
otherwise the product cannot be assembled .
The product cannot be assembled on the ground . Please assemble
the product with the main body elevated to allow room for the
base to be installed .
CAUTION
Please make sure that the power cord is not smashed between the base and the main body .
4 Pull the power cord through the cord control tab.
After assembly, place the product upright to confirm that the base
is firmly attached .
Base (front)
Tabs
Claw
Base (back)
Pull the power
cord through
Power cord control
Power cord
4
Hole

Publicidad

loading