Publicidad
Idiomas disponibles
Idiomas disponibles
MANUAL DE USUARIO | USER'S GUIDE
2.
START UP
1.
Check that the main switch is off.
2.
Connect the plugs to the distributor network
(220/240V – 50/60Hz – 6.8A).
3.
Remove the tank top cover.
4.
Extract and direct the two tank tubes towards
the back of the machine.
© LA ROCCA EXPRÉS S.A. | www.larocca.es
7
5.
Remove the tank and fill with water.
6.
Reinsert the tank. Make sure that the end of
the filter is submerged at the bottom of the tank.
7.
Press the main switch. The machine will start
to load water into the boiler while the blue light
flashes slowly
8.
If the load of water into the tank lasts more
than 2 minutes, the blue light will start to flash
quickly, and charge will stop. Check that there
is still enough water in the tank, switch off and
on again, and load will start again.
9.
When the required level of water in the boiler
has been reached, the blue light will remain on
and the machine will start to heat up, then the
red light will light up.
10.
Wait for 8 minutes for the temperature inside
the boiler reach its working level. Meanwhile,
the air can be bled from the hydraulic circuit by
pressing the dispensing switch until water
comes out of the group.
Make sure that both the steamer and water taps
are closed.
11.
When the red light switched off for the first
time, the boiler temperature has been reached.
Now you can start using coffee, hot water and
steam services.
3.
USE OF THE MACHINE
To extract steam, turn the knob of the steamer
counterclockwise. To stop the extraction, turn it
clockwise until the steam output stops.
ATENTION: Both steam and hot water
extraction must be done with the necessary
caution to avoid burns.
To brew coffee, fill the portafilter with grounded
coffee or insert with the corresponding capsule
(depending on the model). Low the dispensing
lever to start the extraction and raise it when the
desired volume has been reached.
Publicidad
