Sinbo SAH 6101 Manual De Instrucciones página 12

Consult this table if you experience any problems during normal operation.
PROBLEM
Power button is off or not
operating.
Power lamp lights but there
is no humidity discharge
Abnormal humidity odor
Power lamp lights but there
is no humidity discharge
Humidity discharge is too
low
Abnormal noise
Vapor leaks out from the sides of
vapor discharge outlet
Low density
Humidity does not elevate
TROUBLESHOOTING
CAUSES
No power
No water in the water reservoir
Water reservoir cover is loose
The device is new
Dirty or aged water
There is too much water in the
bottom unit
There is too much soiling in the
bottom unit
Water is too dirty or aged in the
reservoir for long time
Vibration due to insufficient amount
of water in the water reservoir.
The device is placed on an
inadequate surface
There is a gap between vapor
discharge outlet and water reservoir
There is too much water in the
bottom unit
Vapor is set to the minimum level Adjust the vapor level
Calcification on the converter
Water is too cold
Water is not clean
Vapor is set to the minimum level Adjust the vapor level
Water reservoir is not placed on
the bottom unit properly.
- 10 -
SOLUTIONS
Insert the power plug into the wall
outlet and operate the device
Add water in the water reservoir
Tighten the cover
Clean the water reservoir with mild
soapy water and rinse thoroghly.
Let it rest for 12 hours with
lukewarm water inside.
Clean the water reservoir, and fill
with clean water.
Empty the water in the bottom unit
and place the water reservoir in its
place again. Or close the cover on
the bottom of the water reservoir
tightly.
Clean the converter of the
bottom unit
Clean the water reservoir, and
fill with clean water
Add water in the water
reservoir
Place the device on an
appropriate and stable surface
Place the vapor outlet cover on the groove
of the water reservoir securely.
Empty the water in the bottom unit
and place the water reservoir in its
place again. Or close the cover on
the bottom of the water reservoir
tightly.
Clean the converter of the
bottom unit
Only use water at room temperature
Clean the water reservoir and fill
with clean water.
Place it on the bottom unit properly
and check