Publicidad
Idiomas disponibles
Idiomas disponibles
3
Install new receiver logic board
3.1 Connect the wire harnesses to
the new receiver logic board.
NOTE: A TEST OF THE SAFETY REVERSE SYSTEM IS NECESSARY FOR SAFE OPERATION.
Programming
1
Program a remote using the learn button
1.1 Press and release the Learn button on the garage door opener. The Learn indicator light will
glow steadily for 30 seconds.
3.2 Insert the antenna wires through the holes in
the end panel. Snap the receiver logic board into
place on the end panel and fasten with screws.
Antenna
NOTE: Some models will
wires
require the short antenna
wire to be placed in the
traps of the end panel.
Learn
Indicator
Light
Yellow Learn
Button
3.3 Reinsert the wires.
Door control wires:
• white wire into the white terminal.
• white/red wire into the red terminal.
Safety sensor wires:
• white wires into the white terminal.
• white/black wires into the
grey terminal.
Antenna wires
1.2 Within 30 seconds, press and hold the
button on the remote control.
2
3.4 Install the light lens by aligning with
the hinges and snapping into place.
Reconnect power.
To insert or remove the wires
NOTE: When installing the light lens, ensure the antenna
from the terminal, push in the
wires are hanging straight down.
tab with a screwdriver tip.
1.3 Release the button when the garage door
opener light blinks. It has learned the
code. If light bulbs are not installed, two
clicks will be heard.
Publicidad
