Vonyx VSA BT Serie Manual De Instrucciones página 5

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. MICROPHONE/LINE VOLUME LEVEL
Controls the microphone/line input volume
2. MP3 VOLUME LEVEL
Controls the MP3 input volume
3. TREBLE CONTROL
Adjust the high frequencies of the corresponding
channel
4. BASS CONTROL
Adjust the low frequencies of the corresponding channel
5. LINE/MICROPHONE SWITCH
Press to switch between line- and microphone input
6. XLR LINE/MICROPHONE INPUT
XLR connector for line/microphone signal input
7. XLR MIX OUTPUT
XLR connector for mix signal output
8. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord (top). For
instructions on how to change the fuse (bottom), see
"REPLACING THE FUSE"
9. POWER SWITCH
Turn the device ON or OFF
MEDIAPLAYER
1. USB SLOT
You can play media files from a USB device by connecting the device
to this slot
2. DISPLAY
The display shows multiple forms of information, for
example current MODE, elapsed time, etc
3. MODE BUTTON
Press to change modes between playing USB, MP3 and BT
4. PLAY/PAUSE BUTTON
Press this button to start or pause play
5. FOLDER BUTTON
Press this button to enter FOLDER selection
6. PREVIOUS BUTTON
Press this button to go to the previous track. Press and hold to scan
backwards within tracks
7. NEXT BUTTON
Press this button to go to the next track.
Press and hold to scan forwards within tracks
5