Beamz Rage 1000 SNOW Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
INSTALLATION
Attention:

The suspension construction should be such that it can support 10 times the weight of the product per hour.

Always use the supplied mounting bracket to hang the product.

The product should be attached to the supplied mounting bracket using a mounting clamp (not included).

The product must always be secured by means of a safety cable.

Make sure that no individual stands or can walk under the product during installation, repair, etc.

The user is responsible for the product, its installation and the safety of the whole. If the user is not able to do so, an
external expert must always be called in to check the product and take responsibility.

The user must have the product and the installation checked at least once a year by an external expert for safety,
technical operation, etc. The user must also have the product and the installation checked by an external expert at
least once a year.

Keep out of the reach of children.

For indoor use only.
OPERATION
Once the reservoir has been filled. Connect the power lead into the machine and earthed mains outlet. Then
you can switch the power on by ON/OFF switch.
The stand-by LED of the remote control lights up. Press the red button and machine will produce a snow effect.
WIRELESS REMOTE CONTROL
The wireless remote control have 4 buttons. Press one of the buttons (A,B,C or D) and the snow machine will
produce snow as long as you press the button.
4
CAUTION: Please consider the respective national norms during the
installation! The installation must only be carried out by an
authorized employee or dealers!
Do not allow the pump to run dry!