Esoteric AB-T1GL1 Manual Del Usuario página 5

AB-T1GL1 (for rear post installation)
Positioning indentation
for 9-inch arm
Positioning indentation
for 10-inch arm
Positioning indentation
for 12-inch arm
Bottom
AB-T1GL2 (for front post installation)
Positioning indentation
for 10-inch arm
Positioning indentation
for 12-inch arm
Bottom
When placed correctly, the tops of the
arm base and the arm base post should
be almost the same height .
If there is a large height difference
between the arm base and the arm
base post, the positioning indentation
and the pin might not be aligned . Try
installing the arm base again .
4
Fix the arm base in place.
Tighten the arm base attachment
thumbscrew to fix it in place .
o After fixing it in place, confirm that
there is no looseness in the arm base .
5
Attach the tonearm to the
arm base.
Refer to the tonearm owner's manual
for installation procedures .
When attaching an MH-9B/9Bt/10B/10Bt,
insert the adapter included with this kit
into the hole in the arm base from below
before installing the tonearm .
6
Install the motor unit.
Following the instructions starting
with procedure 10 on page 16 of the
Grandioso T1 Owner's Manual, install
the motor unit .
Adapter
5