ESX SIGNUM SXE1000.5 Manual De Uso página 8

Please read the user's manual carefully before the installation and the first operation
of the amplifier.
SPECIFICATIONS
Output Power RMS FRONT & REAR
Output Power RMS SUB
Output Power Max. FRONT & REAR
Output Power Max. SUB
Loudspeaker impedance FRONT & REAR
Loudspeaker impedance SUB
Frequency Response FRONT & REAR
Frequency Response SUB
Total Harmonic Distortion FRONT & REAR
Total Harmonic Distortion SUB
Signal-to-Noise Ratio
Input Sensitivity
Input Impedance
Highpass Filter FRONT & REAR
Lowpass Filter SUB
Subsonic Filter SUB
Bass Boost SUB
Operating Voltage
Fuse Rating
Dimensions (B x H x L)
All Specifications are subject to change
IMPORTANT NOTES PRIOR TO INSTALLATION
- This device is only suited for a 12 volt system with negative ground.
- The radiated heat while operation requires sufficient air circulation at the place of installation. It is
very important that the heat sink fins do not have contact with any metal parts or any surfaces which
could impair air circulation. The amplifier may not be installed in small closed location or spaces
without air circulation (e.g. spare wheel recess or below the vehicle carpeting). We recommend the
installation in the vehicle's trunk. Ensure sufficient protection against vibrations, dust and dirt.
- Ensure that the input and output cables are sufficiently separated from the power supply cables.
Otherwise interferences may occur.
- Ensure the accessibility of the fuse and the operating elements after installation.
- The reliability and performance of the amplifier depends on the quality of installation. Preferably
consult an expert to install the system, particularly if you want to install several loudspeakers.
8
SXE1000.5
4 x 75/125 W @ 4/2 Ohms
1 x 200/350/500 W @ 4/2/1 Ohms
4 x 150/250 W @ 4/2 Ohm
1 x 400/700/1000 W @ 4/2/1 Ohms
2 – 8 Ohms
1 – 8 Ohms
3 Hz – 52 kHz (-3 dB)
9 Hz – 350 Hz (-3 dB)
< 0,027 % (1 kHz)
< 0,1 % (100 Hz)
> 112 dB
0,2 – 7 V
20 kOhms
32 – 2000 Hz @ 12 dB/Octave
32 – 300 Hz @ 12 dB/Octave
10 – 60 Hz @ 12 dB/Octave
0 -12 dB @ 40 – 60 Hz
+12 V (9 – 15 V), negative ground
2 x 40 A
220 x 51 x 360/402 mm