Publicidad
Idiomas disponibles
Idiomas disponibles
3). Refrigerant LED indicator
• During the cooling operation (compressor enabled), this re-
frigerant LED indicator will lights up constantly.
DE
• After the inside cabinet reach the set temperature, the refrig-
erant LED indicator will flashes continuously.
• When defrost start, the refrigerant LED indicator light off.
4). Defrost LED indicator
• During the defrost operation, this defrost LED indicator will
lights up constantly.
• After the defrost operation, defrost LED indicator will lights
off.
Cleaning & maintenance
• ATTENTION! Always disconnect the appliance from the pow-
er supply and cool down before storage, cleaning & mainte-
nance.
• Do not use water jet or steam cleaner for cleaning and do not
push the appliance under the water as the parts will get wet
and electric shock might be resulted.
• If the appliance is not kept in a good state of cleanliness, this
can adversely affect the life of the appliance and result in a
dangerous situation.
• Food residues should be regularly cleaned and removed from
the appliance. If the appliance is not cleaned properly, it will
reduce its lifespan and may result in a dangerous condition
during use.
Cleaning
• Clean the cooled exterior surface with a cloth or sponge
slightly dampened with a mild soap solution.
• For reasons of hygiene, the appliance should be cleaned be-
fore and after use.
• Avoid water contacting the electrical components.
• Never immerse the appliance in water or other liquids.
• Never use aggressive cleaning agents, abrasive sponges, or
cleaning agents containing chlorine. Do not use steel wool,
metallic utensils, or any sharp or pointed objects for cleaning.
Do not use petrol or solvents!
• No parts are dishwasher safe.
Parts
How to clean
All accesso-
• Soak in warm, soapy water for
ries such as
about 10 to 20 minutes.
rack holders,
• Rinse under running water
etc.
thoroughly.
External
• Wipe clean with a soft cloth and
glass sur-
a little neutral detergent. Make
faces
sure no water or moisture en-
ters inside the of the appliance.
Interior glass
• Remove any food deposits.
surfaces
• Wipe clean with a soft cloth and
a little mild detergent. Make
Glass door
sure no water or moisture en-
and glass
ters inside the of the appliance.
rack
10
Maintenance
• Check the operation of the appliance regularly to prevent se-
rious accidents.
• If you see that the appliance is not working properly or that
there is a problem, stop using it, switch it off and contact the
supplier.
• All maintenance, installation and repair work must be car-
ried out by specialised and authorised technicians, or recom-
mended by the manufacturer.
Transportation and Storage
• Before storage, always make sure that the appliance has
been disconnected from the power supply and completely
cooled down.
• Store the appliance in a cool, clean and dry place.
• Never place heavy objects on the appliance as this could
damage it.
• Do not move the appliance while it is under operation. Dis-
connect the appliance from power supply when moving and
hold it at the bottom.
• Special care must be taken when moving or transporting the
machine due to its heavy weight. With at least 2 persons or
using a cart. Move the machine slowly, carefully, and never
incline more than 45°.
Troubleshooting
If the appliance does not function properly, please check the
below table for the solution. If you are still unable to solve the
problem, please contact the supplier/service provider.
Problems
The appliance does
not start cooling
after connect to
electrical power
supply.
Cooling is not
Remark
enough.
Dry all
parts well
at last.
Possible cause
Possible solution
Thermal cut-out
Contact the
activated
supplier.
The compressor is
defective.
The power plug/
Check the connec-
inlet is not
tion and make sure
connected properly
all the connections
with the power
are correctly
supply.
connected.
The appliance
Move the appliance
is under strong
a new location
sunlight radiation
to avoid direct
or close to a heat
sunlight.
source.
The doors are not
Close the doors
properly closed or
properly.
the sealing gasket
is defective.
Too much food is
Place less food in-
placed inside the
side the appliance.
appliance.
Surrounding
Check that if
ventilation is
sufficient ventila-
insufficient.
tion is provided by
allowing at least
20cm away from
other objects or
wall.
Publicidad
