Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Remove the screws in the chute base. See Figure 4.
3.
Align the holes in the chute base with the holes in the lower chute and
secure with the previously removed screws. See Figure 5.
Installing the Recoil Starter Handle
1.
Remove the eye bolt and handle knob from the manual bag.
Figure 4
Figure 5
ASSEMBLY
2.
Place the eye bolt and handle knob on the upper handle as shown in Figure 6.
Do not fully tighten the hardware until instructed to do so.
NOTE: The opening of the eye bolt should face toward the back of the snow
blower.
3.
Slowly pull the recoil starter handle up towards the eye bolt.
4.
Slip the recoil starter rope into the eye bolt from the back side of the snow
blower. See Figure 6.
5.
Securely tighten the eye bolt and handle knob.
Set-Up
Fuel Recommendations
Operating the engine with E15 or E85 fuel, an oil/gasoline mixture, dirty
gasoline, or
gasoline over 30 days old
may result in damage to your engine's carburetor. Subsequent damage
would
be covered under the manufacturer's warranty.
not
Use automotive gasoline (unleaded or low leaded to minimize combustion chamber
deposits) with a minimum of 87 octane. Gasoline with up to 10% ethanol (E10)
or 15% MTBE (Methyl Tertiary Butyl Ether) can be used. Never use an oil/gasoline
mixture or dirty gasoline. Avoid getting dirt, dust, or water in the fuel tank. DO
NOT use E15 or E85 gasoline.
•
Refuel in a well-ventilated area with the engine stopped. Do not smoke or
allow flames or sparks in the area where the engine is refueled or where
gasoline is stored.
•
Do not overfill the fuel tank. After refueling, make sure the tank cap is closed
properly and securely.
•
Be careful not to spill fuel when refueling. Spilled fuel or fuel vapor may ignite.
If any fuel is spilled, make sure the area is dry before starting the engine.
•
Avoid repeated or prolonged contact with skin or breathing of vapor.
7
Recoil Starter Handle
Eye Bolt
Handle Knob
Figure 6
CAUTION
without fuel stabilizing additive
Publicidad
