Axxess AXGM-10 Instrucciones De Instalación página 2

From the 16-pin harness:
• Connect the Red wires to the ignition wire of the aftermarket radio.
• Connect the Orange/White wire is not used in this application.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear
negative speaker output.
• Connect the Blue/White wire to the radio's amp turn on wire.
• Connect the Brown wire to the mute wire of the aftermarket radio. If the
aftermarket radio does not have a Mute wire, tape up the Brown wire.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
AXGM-10
Connections to be made
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
• Connect the Green/Purple wire to the reverse wire of the aftermarket
• Plug the 16-pin harness into the AXGM-10.
From the 20-pin GM harness:
• Connect the Yellow wire to the radio's 12 volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Plug the 14-pin harness into the AXGM-10
The Black/Yellow wire is for the OnStar volume adjustment. This will be discussed
in the OnStar Level Adjustment section of this instruction.
• With all connections completed to the aftermarket radio, plug the 16 and 20-pin
• Reconnect the negative battery terminal.
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again
2
navigation radio.
navigation radio.
Installing the AXGM-10
GM harnesses into the vehicles wiring harnesses.
to test the radio.