PRETUL EBA-5P Instrucciones página 19

Assembly
• Mount the tool on a bench or work table. Fix the base
with bolts (not included)..
• The place you determine to set the tool shall be perfectly
leveled and with enough space around it to adequately
handle and support the work piece.
Mount the Accessories
• To mount switch the tool Off and unplug it.
• The tool accessories are needed to gain an efficient and
safe operation. Do not run the tool when there are
accessories not installed.
• The tool includes accessories for both wheels (left and
right). The illustration shows the mounting right side of the
tool. Repeat the same procedure to mount the left side
wheel.
CAUTION • Take your time to examine all the
accessories before mounting to prevent fixing them in the
wrong side of the machine.
CAUTION
• For a safe operation, the edges of the
tool rest (A) as well as the edges of the spark arrester
guards (B) need to be adjusted 1/16" away from the
grinding wheel.
• The smaller screws and washer kits are needed to fix the spark arrester guards (B).
• To adjust the eye proctors (C) in their mounting rods, loosen and tighten the hex screws placed in the rear
face or the eye protectors (D). Loosen enough to be able to freely adjust with your hand, but not too much to
allow keeping it in place after releasing. Always position the eye protector between your eyes and the grinding
wheel.
A
D
C
B
7
ENGLISH