Publicidad
Upper
Handle
Rope
Upper
Guide
Hose
Handle
Bracket
Wing
Nut
Lower
Hose
Handle
Bracket
Carriage
Screw
Blower Chute
Hose
Assembly
Bag
Figure 1
This unit is shipped without gasoline or
IMPORTANT:
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.
ASSEMBLY
Safety Glasses
Lower
Handle
Handle
Knobs
Wing
Nuts
Operator's
Manual
Bottle of
Engine Oil
6
NOTE:
Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses, a bottle of engine oil, and
the operator's manual are also included in the car-
ton. See Figure 1.
OPENING CARTON
•
Cut each corner of the carton vertically from top
to bottom.
•
Remove all loose parts.
•
Remove loose packing material.
REMOVING UNIT FROM CARTON
•
Lift unit from the rear to detach it from underlying
carton material and roll unit out of carton.
•
Check carton thoroughly for any other loose
parts.
NOTE:
Make sure not to crimp cables while
removing loose parts or the entire unit from the
carton.
LOOSE PARTS IN CARTON
•
Upper and Lower Handle
•
Hose Assembly
•
Bag
•
Blower Chute
•
Safety Glasses
•
A Bottle of Engine Oil (may be located in bag)
•
Operator's Manual
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground onto the retaining post on the
engine. This will prevent accidental starting of the
engine. See Figure 2.
Retaining Post
Disconnect and Ground to Post
Figure 2
(See Figure 1)
Spark
Plug Wire
Publicidad
