OHAUS Scout TAD7-S Manual De Instrucciones página 3

Auxiliary Display
INTRODUCTION
This Auxiliary Display is for use with OHAUS Scout STX, SPX, SKX and SJX
series products.
KIT CONTENTS

Auxiliary Display (TAD7-S)

Mounting Brackets (2)

Instruction Manual
INSTALLATION
1. Install the Interface module on the mini DIN port (round connector)
located at the rear side of the balance as shown. During this process,
please make sure the balance is powered off.
Notes:

Please make sure the small triangle mark (▲) on the round connector is
at the bottom and then plug in.

The appearance of your model may be different.
2. The Auxiliary Display operates automatically.
If the communication is lost, power off the balance. And make sure the auxiliary
display's round connector is installed properly on the balance. Then power on the
balance to restore the connection with the Auxiliary Display.
AUXILIARY DISPLAY MOUNTING & PLACEMENT
OPTIONS

Table top placement: The Auxiliary Display may be placed on a flat
surface without additional hardware.

Direct wall mounting: The Auxiliary Display may be mounted to a wall
using two screws (not included). Select appropriate sized screws that fit
into the holes in the back of the Display.

Bracket wall mounting/table mounting: Attach the two mounting
brackets. Position the Auxiliary Display where desired on the wall or table.
Note: When installing the mounting brackets, insert round pins into holes in the
back of the display and then slide each bracket to lock into place. Mounting
brackets may be attached in two different orientations to provide optimum viewing
angle.
EN-1
Mini DIN port
(Round connector)