BOMANN HSM 8007 NE CB Instrucciones De Servicio página 51

1. Pull the protective cap off.
2. Slide the switch towards "0" in order to turn on the appliance.
3. Guide the tip of the shaving head into the nostril or auricle.
WARNING:
Only remove the prominent nose or ear hair. Do not forcefully push the appliance into the
nostril / auricle. You can hurt yourself when it is inserted too deep!
4. Slide the switch back towards "1" after usage in order to switch off the device.
5. Clean the shaving head with the cleaning brush after usage.
6. Set the protective cap onto the device.
WARNING:
• Do not submerge the unit in water.
• The cutting blade is sharp. Do not touch it! There is the danger of injuries.
CAUTION:
• Do not use a wire brush or other abrasives.
• Do not use sharp or abrasive cleaning agents.
1. Switch off the appliance before cleaning.
2. Remove the battery from the battery compartment.
3. Loosen the shaving head by turning it anticlockwise and remove it. Remove the cutting
blade holder carefully.
4. Remove remaining hair from the blade holder using the cleaning brush. You can also
blow off the remaining hair from the holder.
5. Replace the cutting blade holder into the cutting head.
6. Set the cutting head onto the device. Turn it tight clockwise until it snaps audibly into
place.
7. Set the protective cap onto the device.
Usage
Cleaning
GB
51