Publicidad
Idiomas disponibles
Idiomas disponibles
4. Enclosure Installation
4.5 AC Power Connection
The SRW12USNEMA comes with a panel of 4 fans mounted in the front door. The fans receive power via the included NEMA 5-15 to C13 power cord
plugged into the C14 inlet on the bottom of the door. The cord must be properly routed and installed before the unit will be fully functional.
Power Cord Routing
To allow the door to swing fully open and for maximum cord length,
connect the power cord to the C14 inlet and route along the bottom of
the unit on the hinged side of the door. The cord must emerge from the
bottom cable routing slot on the side to which the door is hinged.
Creating a Drip Loop
For added safety, a drip loop must be implemented in the power cord for
proper installation of the SRW12USNEMA. To create a drip loop, make
sure that the power cord is routed down from the unit and must rise
back up again to the power outlet, forming a loop in the cord that will
guide any moisture away from both the outlet and the unit.
5. Enclosure Configuration
Before installation, be sure to plan the location and arrangement of components within the enclosure. Be sure all mounting rails are reversed or
adjusted for depth, depending on your equipment configuration. Note: Always disconnect power input and remove equipment before attempting to
reconfigure the enclosure.
5.1 Door Locks
The front and back doors have locks that are accessible by the included keys. Each side panel locks using an L-shaped lever on the inside of the
enclosure.
1
To unlock and remove the side panels, lift the shorter leg of the "L" up (labeled
on the side panel and remove it from the enclosure.
To re-lock the side panels, secure it in the proper position, lift the shorter leg of the "L" up (labeled
2
into the hole that it was in initially (labeled
side panels, you will need to have access to the interior of the enclosure.
( continued )
B
). Once it is in place, push the shorter leg of the "L" down to lock it. Note: To lock and unlock the
A
1
5
DRIP LOOP
A
) and pull it away from the side panel (labeled
A
) and push it toward the side panel, back
B
B
2
B
). Pull the tab
A
Publicidad
