JVC GR-AX627 Manual De Instrucciones página 34

34
IN/OUT
RM-V700U (optional)
Downloaded from: https://www.usersmanualguide.com/
REW/FF CANCEL
IN/OUT
R.A. EDIT
PLAY/PAUSE
STOP
To EDIT To AUDIO and
VIDEO out
connector
Editing cable
(optional 3.5 ø
Audio and Video
mini-plug cable)
cable (optional)
C A
B
To Remote To AUDIO and
PAUSE VIDEO IN
connectors
To Pause-In
VCR (Recording deck)
ON/OFF
VCR REC STBY
CANCEL
IN OUT IN
1 0:00:25 1 0:00:25
2 2 0:03:18
3 3 0:02:33
4 4 0:04:11
5 5
6 6
7 7
8 8
COUNTER 0:00:25 COUNTER
TOTAL 0:00:00 TOTAL
PREPARE CAMCORDER
2
Insert a recorded tape and set the power switch to
PLAY.
PREPARE VCR
3
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR's instructions).
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
1
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
● The RM-V700U can be used to operate other camcorder
functions as well. Point the RM-V700U at the camcorder's
remote sensor and press any of the following buttons
(function appears in parentheses):
— ON/OFF (camcorder R.A. EDIT)
— IN/OUT (camcorder IN/OUT)
— CANCEL (camcorder CANCEL)
OUT
0:01:05
● There must be at least one second between an in-point and
0:03:31
0:02:53 its corresponding out-point.
● The camcorder prerolls during R.A. Edit, so there must be at
least 15 seconds of recording material prior to any in-point.
● Blank portions of tape cannot be registered as in-points or
0:04:11
out-points.
0:01:13
● If it takes more than 5 minutes to search for an in-point, the
VCR's Record-Pause mode is cancelled and editing doesn't
take place.
● Pressing R.A.EDIT clears all in- and out-points from
memory.
● Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
EDITING (cont.)