Publicidad
Idiomas disponibles
Idiomas disponibles
Seat Fabric
7
DO NOT MACHINE WASH.
For metal and plastic parts,
use only lukewarm water
and mild soap.
To remove the seat fabric
for maintenance, pull out all
the plates from the tab on
the seat base (Fig. 7a).
To reattach the fabric,
insert the warning label
side towards the of the seat
base. Fold the fabric over
and insert the rear center
plate into the tab. Continue
to connect all plates around
the seat base tabs. All plates
and tabs must be secured
before use (Fig. 7b).
Maintenance and Cleaning
8
Check this product regularly before using it, and do
not use it if any part is loose or missing or if there
are any signs of damage. Do not substitute parts.
Contact the manufacturer if replacement parts or
additional instructions are needed.
Clean this product after each use, using mild
household dish soap. Please use only a soft bristle
brush, sponge or cloth to clean the surface or
remove particles of food.
DO NOT submerge the product in water. Surface
clean only.
17
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Fig. 7a
Fig. 7b
FCC Statement
This device complies with Part 15 of the FCC rules. Operation is subject
to the following two conditions:
1 this device may not cause harmful interference, and
2 this device must accept any interference received, including interfer-
ence that may cause undesired operation.
WARNING:
modifications to this unit not expressly
modifications to this unit not expressly
approved by the party responsible for
approved by the party responsible for
compliance could void the user's authority
compliance could void the user's authority
to operate the equipment.
to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment gener-
ates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful inter-
ference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the inter-
ference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Copyright © 2023, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados.
Changes or
Changes or
18
Publicidad
