Maintenance Recommendations; Technical Support - Soler & Palau DHUM-12 E Manual De Instalación. Instrucciones De Uso

Continuous water drainage
1. Remove the water tank, so that you can connect the pipe to the water outlet tube (Fig. 3).
2. Connect a PVC pipe with an interior diameter of 14 mm to the water outlet tube and secure
it with a nylon hose clip. The extraction tube must always be flat to the floor and free of any
kink that might obstruct the flow of water.
3. Replace the water tank in the unit, and the latter will restart operating after 3 minutes ap-
prox.

MAINTENANCE RECOMMENDATIONS

1. Disconnect the device from the power supply before carrying out any maintenance opera-
tion.
2. Clean the exterior of the device using a cloth moistened with water. Do not use detergents
or abrasive products.
3. Clean the air filter once every two weeks with hot water (40ºC). Do not use detergents or
abrasive products. (Fig. 3)

TECHNICAL SUPPORT

S&P's extensive Official Service Network guarantees appropriate technical support.
Should you notice any anomaly in the operation of the device, please contact any of the ser-
vice centres listed to obtain technical support.
Any operation on the device which is not strictly necessary for its installation, carried out by
persons other than from S&P's official service centres, will invalidate the guarantee.
To clarify any query you may have concerning S&P products, contact the After Sales Service
Network if you are based in Spain, or your normal distributor if you are located elsewhere. You
can find their location by visiting our website www.solerpalau.com
REMOVAL FROM SERVICE / RECYCLING
EC regulations and our responsibility to future generations require us to recycle
materials; please do not forget to place all residual packaging materials in the re-
levant recycling bins and take all redundant equipment to the nearest Recycling
Centre.
The refrigerant gas used in models DHUM-12E/ 16E/ 20 E is of type R134a. The refrigerant
gas used in model DHUM-30E is of type R410a. Both types of refrigerant gas are covered by
the Kyoto Protocol. (CE) N 842/2006.
22