Changing The Userlevel; Changing Batteries - Kerbl 29392 Instrucciones De Uso

List of calibration curves
Pressing the or key in the measuring window for at least 3 seconds and a list
with all available sorts will appear. Select your sort by pressing
it with the key. The measurement will continue automatically.
Activation of the "super user" function
2 times - Options – Unlock
Enter the 4-digit password by using the
button.

Changing the Userlevel

Changing from advanced user to single user:
Make sure that you have activated the "super user" functions according to the instructions above. Afterwards change to
the menu and choose „Options". In the submenu please select „o Userlevel" (2 times
Confirm by pressing the
Changing from single user to advanced user:
Keep both the buttons and
main menu. Activate the the "super user" functions according to the instructions above. Navigate to "Options – o Userle-
vel" and confirm by pressing the
Measuring value out of range
If the measure value is blinking, the valid measuring range is exceeded (limits see list on
page 2). In this case the accuracy will be decreasing.

Changing batteries

Your new device is provided with batteries. Please find enclosed the manual for
changing of batteries:
1. At first remove the rubber protective housing. For that, hold the rubber housing at the up-
per side and pull it over. You have to remove the protection cap before.
2. Press with your finger onto the arrow of the battery cap und pull it back.
3. Remove the empty batteries.
4. Put four new batteries in the device. Make sure that the position of the battery poles
is correct.
5. Press down the batteries and close the cap.
button (standard is the 4-digit serial number) and confirm by pressing the
button. Now the single user is activated.
pressed directly after switching on the device. Your device automatically starts the
button.
or and confirm
17
- Options – o Userlevel)