Installation Instructions
LOCATION
Remove exterior and interior packaging, wipe the outside thoroughly with a soft dry cloth and the
inside with a wet, lukewarm cloth. Avoid placing the appliance in a narrow recess or near any heat
source, direct sunlight, or moisture. Let air circulate freely around the appliance. Keep the rear of the
appliance 10.6 cm (4 inches) away from the wall, ensure there is 20.3 cm (8 inches) of clearance
between each side and the surrounding walls and ensure there is 30.5 cm (12 inches) of clearance
between the top of the appliance and any cabinets or ceilings. This will allow proper air circulation.
1. Place the appliance in a location where extension cords are not necessary.
2. Select a location with consistent year round temperatures. It is not recommended to operate
the appliance when surrounding air temperature is below 5°C (41°F), though it will not harm the
appliance to stand in any temperature below 5°C (41°F), provided the temperature control is set
to avoid running the appliance. In order to keep operating cost down, do not place the appliance
near a stove, furnace, heat register or in direct sunlight. Avoid placing the appliance in a damp or
moist area, such as basements.
FEATURES
1. Thermostat dial
2. Freezer shelves
3. Magnetic gasket
4. 4 Door bins
5. Drip tray
OPERATION
To avoid vibration, the cabinet must be set level.This is accomplished by adjusting the (2) front
leveling legs located under the freezer cabinet. To start the freezer, turn the temperature control to
the position corresponding to the desired cooling.
0 = No Cooling
3, 4 = Medium Cooling
The freezer temperature will vary depending on the quantity of the food stored and on the frequency
with which the door is opened.
1= Minimum Cooling
7= Maximum Cooling
4