Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions
Automatic shut off
The dehumidifier will turn off automatically when the bucket is full,
or when the bucket is removed or not replaced in the proper
position.
The bucket must be replaced in the proper position for the
dehumidifier to work. The light will be on and the
dehumidifier will not run if the bucket is not in the proper
position.
Disposing of collected water
1
. Empty the bucket manually.
When the bucket is full, pull out by
grasping the handle and empty it
into a large sink or tub and then
replace it properly.
NOTICE
Do not remove while
operating the dehumidifier.
It can cause water to drop on the
base pan or the floor.
Empty the bucket when the indicator
light turns on.
NOTICE
It is advisable to carry the
bucket by supporting it from the
bottom as well as by the handle.
Carrying by only the handle may
cause the handle or bucket cover to
break.
12 Dehumidifier
2
. Attach a length of garden hose to the threaded drain hose
connection to carry water to the drain.
1. Connect a garden hose to the
threaded drain hose connector.
(Fig1)
2. Remove the drain-hole cover.
(Fig2)
3. Push hose connector tightly into
the drain-hole on Rear Grille.
(Fig3-1,3-2)
4. Press the hose down and make
sure the "Arrow" is pointing upward.
(Fig4-1,4-2)
5.The connection should be resemble
Fig5 when complete.
The hose attachment will
NOTICE
accept a standard garden hose
fitting.
Do not over tighten the hose when
connecting it to the hose connector,
use a rubber washer and tighten by
hand firmly without stripping the
plastic threads.
When being attached to hose connector drain hose connection, do not bend or kink the hose.
The hose should lie flat fom the dehumidifier to the drain.
Water level
control switch
DRAIN HOLE
COVER
Fig2
HOSE
CONNECTOR
Fig3-2
Fig4-1
INSERT
Fig5
Fig1
HOSE
CONNECTOR
Fig3-1
Fig4-2
TAKE OUT
Publicidad
