Behringer ULTRABASS BXD3000H Guia De Inicio Rapido página 6

10
ULTRABASS BXD3000H
ULTRABASS BXD3000H Controls
(2) (3) (5) (6) (7)
(4)
(16)
(8) (10) (12) (14) (15)
(9) (11) (13)
(17) (20) (19)
(18) (21) (22)
Step 2: Controls
(EN)
(1)
(1) The POWER switch turns the amplifier on. (13) Push this ON button to activate the
ULTRABASS function. The LED in the button will
(2) Connect your bass guitar to the INPUT jack using
light up to indicate ULTRABASS is on. You can
a ¼" mono plug (unbalanced).
also control this effect with the included
(3) The GAIN 1 knob adjusts the input gain for footswitch.
channel 1.
(14) Use the MASTER control to set the
(4) The CH 2 button switches between channel 1 overall volume.
and channel 2. This can also be done using the
(15) The PHONES jack is for connecting a
included footswitch.
pair of headphones.
(5) The GAIN 2 knob adjusts the input gain for
(16) Power is supplied via the included IEC connector.
channel 2. As you turn the knob clockwise,
the distortion effect is continuously blended in. (17) Use the balanced DIRECT OUTPUT (XLR) to route
the audio signal from your BXD3000H to the
(6) The SHAPE knob adjusts which frequencies are
input on a mixing console.
scooped out of your bass tone. It only affects
channel 2. (18) Connect your BXD3000H to an external speaker
using a speaker cable connected to the SPEAKER
(7) The LEVEL knob adjusts the volume of channel 2.
OUTPUT jack.
Use this control to balance the volume between
channels 1 and 2. (19) Connect the SEND jack to the input on your
effects device. Connect the output on the effects
(8) The FBQ EQUALIZER has 7 slide controls, one for
device to the RETURN jack on the BXD3000H.
each frequency band. The maximum boost/cut
is 12 dB. (20) The CD IN jacks (RCA) allow you to connect an
external stereo signal. For example, you can
(9) The FBQ switch activates the FBQ
play along with music from a CD or MP3 player.
spectrum analyzer. The control LEDs, normally
identical when FBQ is off, now show the (21) Send your signal (before the power
energy content of each frequency band amp stage) via the LINE OUT jack with a
with a corresponding degree of brightness. ¼" mono cable (unbalanced).
The equalizer is always active regardless of the
(22) Connect the included footswitch to the
FBQ function.
FOOTSW(ITCH) jack to switch between
(10) The COMPRESSOR knob controls the channels and activate/deactivate the
compression intensity. ULTRABASS function.
(11) Push this ON button to activate the compressor
for both channels. The LED in the button will
light up to indicate the compressor is on.
(12) The ULTRABASS control allows you to add
ultra-low frequencies one octave below your
bass signal. The ULTRABASS effect is available
for both channels.
11
Quick Start Guide