JVC GR-D390U Manual De Instrucciones página 21

NOTES:
●
The time code cannot be reset.
●
During fast-forwarding and rewinding, the time
code indication does not move smoothly.
●
The time code is displayed only when "TIME
CODE" is set to "ON". (
Quick Review
Enables to check the end of the last recording.
1) Press QUICK REVIEW during the Recording-
Standby mode.
2) Tape is rewound for about several seconds
and played back automatically, then pauses in
the Recording-Standby mode for the next shot.
●
Distortion may occur at start of playback. This is
normal.
Recording From The Middle Of A Tape
1) Play back a tape or use Blank Search
( pg. 22) to find the spot at which you want to
start recording, then engage the Still Playback
mode. (See the right column.)
2) Set the Power Switch to "REC" while pressing
down the Lock Button located on the switch,
then start recording.
pg. 34)
VIDEO PLAYBACK
Normal Playback
¡ ¡ ¡ ¡
6 6
6 6
1 1 1 1
Speaker
VIDEO/
MEMORY
7
1
Load a cassette. (
2
Set the VIDEO/MEMORY Switch to "VIDEO".
3
Set the Power Switch to "PLAY" while
pressing down the Lock Button located on the
switch.
4
To start playback, press 6.
5
To stop playback, press 7.
●
During Stop mode, press
fast-forward the tape.
To control the speaker volume
Slide the Power Zoom Lever (VOL. +/–) towards
"+" to turn up the volume, or towards "–" to turn
down the volume.
NOTES:
●
The playback picture can be viewed in the LCD
monitor, viewfinder or on a connected TV.
( pg. 23)
●
If Stop mode continues for 5 minutes when power
is supplied from a battery, the camcorder shuts off
automatically. To turn on again, set the Power
Switch to "OFF", then to "PLAY".
●
When a cable is connected to the AV connector,
the sound is not heard from the speaker.
Still Playback
Pauses during video playback.
1) Press 6 during playback.
2) To resume normal playback, press 6 again.
●
If still playback continues for more than about
3 minutes, the camcorder's Stop mode is
automatically engaged.
EN
VOL. +/–
Lock Button
MENU
pg. 18)
1 ¡
to rewind, or
21
to