Prstech DC2 Manual Del Producto página 6

• Remove the battery slot covers and insert 4x AAA batteries into the main unit. Make sure to observe
the correct polarity!
• Mount the main unit to the backplate, and secure it to the magnets.
• Installation is now complete!
Operation
1. ON button
Turn device on
Press ON button. The screen will turn itself on. After 10 seconds it will turn itself off automatically.
Battery status
If the battery power is critically low, the battery status symbol will flash in the upper right corner of
the screen. In this case make sure to replace the batteries immediately.
Troubleshooting
The screen is blue and shows "No camera / Nobody outside"
Make sure the cable is FULLY INSERTED in to the receptacle.
The device won't turn on
Make sure the batteries have enough power. Replace them if necessary.
The image is flickering / jittery / black & white
Make sure the batteries have enough power. Replace them if necessary.
Warranty and Liability
The manufacturer grants a 2 year warranty to a new device. As the manufacturer has no influence on
installation, warranty of the product only applies to the product. If your dealer cannot be contacted, you can
also contact us directly. The manufacturer is not liable for damages to persons or property caused by
improper installation or operation not described in this guide. This includes, among others, any alteration
and modification of the product and its accessories.
Note on Waste Disposal
According to the European WEEE directive, electrical equipment must not be disposed with
DoorCAM DC2 5