Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
3. Align the base panel (E) with the
assembled unit from Step 2 carefully. Tap
the base panel (E) into the unit until the
clips are secured tightly. Repeat this step
to attach the top panel (F) to the
assembled unit.
Note: Recommended to use a rubber
mallet to tap the components together.
4. Check and verify the holes in front edge of
base panel (E) and top panel (F) are
aligned with the holes in left side panel
(C) and right side panel (D). If not, check
and make sure the base panel (E) and
top panel (F) are located at the right
place. Tighten the ST4.8 x 10 mm screws
(AA) to the holes to make the unit
securely fixed.
Hardware Used
AA
ST4.8 x 10 mm
Screw
3
E
Before
4
E
x 12
7
C
After
C
D
AA
F
D
F
Publicidad
