Publicidad
Idiomas disponibles
Idiomas disponibles
• Read, understand, and follow all instructions before operating this device.
• Do not exceed rated capacity. Rated capacity is 300 lbs. (includes user, tools, equipment and personal items).
• Sit down gently. Avoid shock loads caused by jumping or falling onto seat.
• Do not stand on seat.
• Beware of pinch and crush hazards when folding and unfolding.
• Keep out of the reach of children! This device is not appropriate for children's use.
• Use only on smooth, level surface capable of supporting the load.
PREPARATION
Before assembling your Folding Creeper, make sure all
parts are present. If any part is missing or damaged, do not
attempt to assemble or use the product. Contact Banner
customer service for replacement parts.
Package Contents: 1 Creeper Body, 6 Casters, 4 Nuts
Figure 2 - Attaching Creeper Casters
ASSEMBLY INSTRUCTIONS
1. Using the included open-end wrench, attach two Casters
to the threaded holes in the Head Frame section. Use a
5mm hex key to fasten the remaining four Casters to the
Creeper Frame. Insert the threaded Fasteners from the
top and the Casters from the bottom, then tighten with
hex key.
!
WARNING
OPERATING INSTRUCTIONS
1. Unlock the spring loaded Lock Pin by pulling out until
disengaged, at the same time rotate the Head Frame and
Middle Frame upward and back towards the Rear Frame
section until the Lock Pin can engage the Creeper Seat
Locking Sleeve (Fig. 3). Ensure Lock Pin is fully engaged.
2 Flip Head Frame forward until horizontal.
3. Unlock the spring loaded Lock Pin by pulling out until
disengaged, then reverse steps 1, 2 to convert Creeper
Seat into Creeper.
3
Figure 3 - Adjusting Creeper to seat configuration
Figure 4 - Adjusting Seat to Creeper configuration
Publicidad
