Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Each electric scooter was careful ly assembled and inspected before leaving the factory. You have
to install the pedals and rear view mirrors. Follow the installation instructions. Tools Required:
Key; hex key; screwdriver, etc. Each package includes a set of installation tools.
1. UNPACKING THE E-MOPED
1. Remove the protective paper wrapper.
2. Unscrew the four side metal rods.
3. Gut the securing plastic tape from the construction.
4. Remove the front wheel.
5. You will find a package with a set of keys and a remote control on the surface of the carrier
holder.
6. Remove the securing wire at the bottom left.
1.
7. Loosen and then s lide the shaft rod with the axle delimiting rollers out of the front fork.
This will release the E-FICHTL from the metal structure.
8. Slide the E-FICHT out of the structure.
9. Carefully remove the protective plastic film.
1 O. ln the step area you will find the packed front steering column cover, front fender, trunk.
11. ln the storage compartment under the seat, you will find a rechargeable battery, rear-view
mirrors, mounting screws and a user manual.
.
4
Publicidad
