Bosch GDS Professional 24 Manual Original página 12

12 | English
Impact wrench
Weight according to EPTA-Proced-
ure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/Vibration Information
Noise emission values determined according to EN 62841-2-2.
Typically, the A-weighted noise level of the power tool is
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and uncertainty K determined according to EN 62841-2-2:
h
Tightening screws and nuts of the maximum permitted size:
a
h
K
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure and may be used to com-
pare power tools. They may also be used for a preliminary
estimation of vibration and noise emissions.
The stated vibration level and noise emission value repres-
ent the main applications of the power tool. However, if the
power tool is used for other applications, with different ac-
cessories or is poorly maintained, the vibration level and
noise emission value may differ. This may significantly in-
crease the vibration and noise emissions over the total work-
ing period.
To estimate vibration and noise emissions accurately, the
times when the tool is switched off or when it is running but
not actually being used should also be taken into account.
This may significantly reduce vibration and noise emissions
over the total working period.
Implement additional safety measures to protect the oper-
ator from the effects of vibration, such as servicing the
power tool and accessories, keeping their hands warm, and
organising workflows correctly.
Assembly
Changing the Tool
Pull the plug out of the socket before carrying out any
u
work on the power tool.
When fitting an application tool, make sure that it is
u
held securely in the tool holder. If the application tool is
not held securely in the tool holder, it may become loose
and consequently uncontrollable.
Slide the application tool (7) onto the square drive of the
tool holder (6).
1 609 92A 7YG | (18.07.2023)
GDS 24
kg
GDS 24
dB(A)
dB(A)
dB
2
m/s
2
m/s
Operation
Method of Operation
The tool holder (6) (with the application tool) is driven by an
electric motor via a gear and impact mechanism.
The working procedure is divided into two phases:
Screwing in and tightening (impact mechanism in action).
The impact mechanism is activated as soon as the screwed
connection runs tight and load is therefore put on the motor.
The impact mechanism then converts the power of the mo-
tor to steady rotary impacts. When loosening screws or nuts,
the process is reversed.
Starting Operation
Pay attention to the mains voltage! The voltage of the
u
power source must match the voltage specified on the
rating plate of the power tool. Power tools marked
with 230 V can also be operated with 220 V.
Products that are only sold in AUS and NZ: Use a resid-
u
ual current device (RCD) with a nominal residual current
of 30 mA or less.
Setting the rotational direction
Only operate the rotational direction switch (5) when
u
the power tool is not in use.
The rotational direction switch (5) is used to change the ro-
tational direction of the power tool.
Right rotation: Slide the rotational direction switch (5) all
the way down (R).
Left rotation: Slide the rotational direction switch (5) all the
way up (L).
GDS 30
6.1 7.6
/ II
GDS 30
95
106 110
3
8
1.5
Bosch Power Tools
/ II
99
3
13
2