Filling In The Fuel; Automatic Ignition - EINHELL CH 2750 Manual De Instrucciones

Anleitung Comfort-Heizgeräte 31.10.2001 14:24 Uhr
GB
7
Important note for filling in fuel for the first time:
When starting up the heater for the first time,
make sure that at least two hours elapse between
filling in the fuel and igniting the heater. This
waiting period is necessary to allow the wick to be
become saturated with fuel.
Important note for igniting the convection
heater for the first time:
We strongly advise you to start up the convection
heater for the first time outdoors so that the oils
used during the manufacturing process are
combusted out of doors and not inside your living
quarters.
N.B.: Switch off the heater and refill the tank
before it is completely empty.

7. AUTOMATIC IGNITION

The convection heater is equipped with an automatic
ignition system for added safety and comfort.
Two (2) R 20 batteries are included with the heater to
supply the automatic ignition system with the power
required to light up the wick. For this purpose, the
wick must be in its uppermost position.
8
16
Seite 16
Start-up
- Make sure that the batteries are properly in
place. (Figure 4)
- Turn the wick controller in clockwise direction
until the wick has moved all the way to the top.
(Figure 9)
- Press the ignition button so that the ignition
touches the wick and lights it.
- Once the wick starts to burn, release the ignition
button. This will cause the combustion chamber
to be lowered automatically onto the wick.
- Turn the burner back and forth a few times to
ensure that the burner is seated correctly on top
of the wick. (Figure 5)
- Then follow the steps outlined in the next
section.
9
OFF
switch
empty
half full
full
full
empty
half full
ignition
button
wick
controller