Publicidad
Idiomas disponibles
Idiomas disponibles
Airfusion Climate Installation Instructions
on high speed only or fails to operate in reverse function or any other command/s, it is recommended to repair the
communication pairing of the remote and receiver. Please follow the steps below:
A.
Remove the battery cover of the remote, check the 434 MHz sticker area, make sure the battery is installed correctly
and the red LED light indicator will be flashing, it means the remote function is okay.
B.
Turn off the main supply to receiver more than 30 seconds and turn on the main supply to receiver again. Press and
hold the SET button of remote for 8-10 seconds within 60 seconds of turning the power to the receiver. The fan
operates at highest speed in REVERSE mode automatically for approximately 2 minutes and then operates in
FORWARD mode for approximately 2 minutes. During the paring process, DO NOT TOUCH THE REMOTE FOR
4-5 MINUTES.
C.
Press the buttons on the remote to run the fan. In general, performing point A, B, and C should repair the remote
and receiver, and will allow full control of the fan. If not, please do the next step.
11 | P a g e
Publicidad
